7
installation guide
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 10
Uncoil input cord (connected to control box’s
power port) and plug into Power Supply .
Uncoil the Power Cord and connect to the
Power Supply . Place Power Supply on the
ground and extend from the base . Ensure
that the Power Supply and all attached
cords are directed toward the desired surge
protector .
Carefully flip the base over on to its legs .
Important:
Two people are
required to move the bed base . Do not drag across the floor . Do not
rest frame on its side, excessive pressure may damage the legs .
Plug the base into a power source .
A surge protector is strongly
recommended.
Ensure batteries are correctly installed in the back of the remote .
Quickly test functions to verify proper setup before placing mattress on
base . Press FLAT to return the base to a flat position .
Basic setup is now complete! See page 8-9 for remote control
operating instructions .
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
Insert each end of the mattress retainer bar into the inserts at the foot
of the base until the retainer bar is secured in place.
INSTALLATION GUIDE
FOR CUSTOMER SUPPORT, VISIT WWW.ERGOMOTION.COM OR CALL: 1-888-550-3746
