23
Send Number:
This function is mainly used to limit the number of messages sent by the camera every
day, which helps the user to control the cost. When the function is not set to 0, the interval is 10
minutes after each message is sent, and the message can not be sent again after the trigger shooting.
To prevent duplication of information and waste the cost.
Daily Report:
The camera send the current data report of the camera to the specified user as a text
message every day. Including: power information, signal strength, temperature, storage capacity
information, the number of photos and videos.
MMS parameter:
It is used to Setting MMS related Parameter and receiver information.
SMTP parameter:
It is used to Setting SMTP related Parameter and receiver information.
Support SSL (Security socket Layer)
Remote control:
not supported.
You must insert a valid SIM card when using the communication function.
When communication function is open, you must use the PC-side MMS Set software correctly set the
relevant parameters in order to ensure camera communication function works .
4.12. User Interface Stamp
Open the User Interface Stamp, the camera ID, Shooting Date, Temperature and Moon phase will be
displayed on the corresponding pictures taken.
User Interface
Stamp
Single selection
ON
Stamp
Default
OFF
No stamp
4.13. Password
Password protection is to increase security of camera parameters. You should input the correct password
after you open the password protection function.
Password
Password
Single selection
ON
Open password protection
OFF
Close password protection
Default
Password setup
digit
1111
Make up of four numbers from 0 to 9
1111
4.14. TF Card Format
Format TF card
。
This operation will lose the TF card, be careful.
