11
Operators Manual ES-648E
AKKUVEC
Operation
Before using your leaf and waste vacuum cleaner, make
sure that:
•
the unit stands on a firm, level surface,
• the bag is hooked in,
• the suction nozzle is set to the correct height,
• the batteries are charged,
• the key switch is set to „AUS“.
Start the machine:
• Set the key switch to “EIN”.
• Use the potentiometer to set the desired turbine
speed.
• Releasing the handbrake
• Press clutch lever
Shutting down the machine
• Release the clutch lever
• Reduce turbine speed to “0
• Tighten the handbrake lever
• Set key switch to “AUS”.
•
In an emergency situation
• Release the clutch lever
• Set key switch to “AUS”.
Installing the collecting bag
• Slide the opening of the bag over the ejection sheet.
Tighten the catching bag to the ejector channel with
the tension strap.
• There are 4 tabs on the top of the bag. These tabs are
pulled over the guide rail from the outside and attached
to the 4 brass coloured bolts.
Empty the collection bag
• Stop the engine before opening the collecting bag.
• Open the zipper or toggle fastener on the collecting
bag and remove sucked-in material. Wear protective
gloves.
• Close the zipper or toggle fastener on the collecting
bag.
DANGER:
Never operate the leaf and waste suction unit
without a collection bag.
Stop the engine before opening or removing
the bag.
Risk of serious injuries.
Warning:
Highly flammable substances (e. g. embers,
hot barbecue coal) can ignite when you hit a
hot surface.
Risk of injury due to light
flammable substances.
Vacuum waste
For dry paper waste, etc., select the height setting re-
quired for beverage cans.
However, if paper waste is already soaked, a second
operation with deep adjustment (see wet foliage) may be
necessary. As with leaf vacuuming, always ensure that
the collecting bag is clean and permeable to air.
Notice:
After work, the collection bag should be washed out and
dried. Hand or machine washable up to 40°C. Keep the
zipper running smoothly after each wash with a little
talcum.
