Erbauer ERB612GRD, Manual

Page: 20 / 28

For mounting, see the Component list illustration
page.
Screw on the outer flange (5) and tighten with the
two-pin spanner (9).
3. ADJUSTABLE OUTER FLANGE CLAMPING
The outer flange (5) should be adjusted to suit
different disc thickness. For thinner cutting or
diamond discs the raised part of the outer flange is
fitted facing away from the disc (See Fig. 3-2). For
thicker grinding discs the raised part of the outer
flange is fitted facing towards the disc to provide
improved support for the disc hole (See Fig. 3-1).
Always ensure your disc is securely clamped.
Adjusting the protection guard
Before any work on the machine itself, pull the
mains plug.
For work with grinding or cutting discs, the
protection guard must be mounted.
The coded projection (12) on the protection guard
(10/13) ensures that only a guard that fits the
machine type can be mounted.
Loosen the clamping screw (11), if necessary.
Place the protection guard (10/13) with coded
projection (12) into the coded groove on the
spindle collar of the machine head and rotate to
the required position (working position).
The closed side of the protection guard (10/13)
must always point to the operator.
Tighten clamping screw (11).
Warning! Use wheel guard (10) ONLY for
grinding and wheel guard (13) for cutting.
OPERATION
Starting Operation
To start the power tool, push the on/off switch
(1) forward.
To lock the on/off switch (1), press the on/off switch
(1) down at the front until it engages.
To switch off the power tool, release the on/off
switch (1) or, if it is locked, briefly push down the
back of the on/off switch (1) and then release it.
(See Fig. 4)
Operating Instructions
• Clamp the workpiece if it does not remain
Fig. 1
Fig. 2
Fig. 3-1
Fig. 4
Fig. 3-2
Fig. 5
1