Erbauer 3663602795773, Original Instructions Manual

Page: 14 / 40

14
d) The power tool shall not be wet or applied in wet
environment.
e) The voltage of the power source must agree with the
voltage specified on the rating label of the machine.
f) Check the product, its power cord and plug as well as
accessories for damage before each use. Do not use the
product if it is damaged or shows wear.
g) Double check that the accessories and attachments are
properly fixed. One minute testing running in no-load
condition will be helpful to identify the problems.
h) Secure the workpiece. A workpiece clamped with clamping
devices or in a vice is held more secure than by hand.
i) Keep the handles dry to ensure safe control. Grip the
product securely with two hands so you have full control at
all times.
j) The blade and the work piece can be very hot while
working. Do not touch them before they have cooled down.
k) Ensure that the air vents are always unobstructed and
clear. Clean them if necessary with a soft brush. Blocked
air vents may lead to overheating and damage the product.
l) Switch off the power tool immediately if the blade jams. Be
prepared for high reaction torque that can cause kickback.
The blade jams when the power tool is subject to overload
or it becomes wedged in the workpiece.
m) Switch the product off immediately if you are disturbed
while working by other people entering the working area.
Always let the product come to complete stop before
putting it down.
n) Do not overwork yourself. Take regular breaks to ensure
you can concentrate on the work and have full control over
the product.
o) Always keep the power cord behind the power tool.
LASER SAFETY WARNINGS
The laser light used is Class 2 with maximum 1mW power
and 650nm wavelength. These lasers do not normally present
an optical hazard, although staring at the beam may cause
flash blindness.
1400W circular saw MNL_ECS1400_TPS_GB_V1_V20518_20180605.indd 14 6/5/18 3:24 PM