Erbauer 3663602795773, Original Instructions Manual

Page: 31 / 40

31
8. Only apply proper feeding force. Higher feeding force will not increase but lower
the performance of the product, overheat the blade tips and leads to low cutting
surface/edge quality.
9. Keep the product moving at all times, do not stop in one position to avoid grooves.
10. Lift the product from the workpiece before switching it off.
02
Parallel cutting
1. Attach the parallel guide (10) to the product as described above and adjust to the
desired width.
2. Switch the product on and wait until it runs at full speed before placing it on the
workpiece.
3. Place the product laterally to the workpiece and guide the product along the edge.
03
Bevel cutting
1. Adjust the required cutting angle. Ensure the fixation knob (6a) is properly
tightened.
2. Switch the product on and wait until it runs at full speed before placing it on the
workpiece.
3. Place the base plate (8) flat on the workpiece and push the product forward at an
even speed.
After use
1. Switch the product off, wait for complete stop, disconnect it from the power supply
and let it cool down.
2. Check, clean and store the product as described below.
1400W circular saw MNL_ECS1400_TPS_GB_V1_V20518_20180605.indd 31 6/5/18 3:24 PM