Erbauer 3663602795773, Original Instructions Manual

Page: 27 / 40

27
2. Lock the spindle by pressing the spindle lock lever (5) and loosen the locking bolt
(13) anticlockwise with the hex key (24) provided.
3. Remove the locking bolt (incl. spring and washer) (13) and locking flange (14) from
the spindle.
4. Open the lower guard (11) completely by moving the retraction lever (17) clockwise
and holding it in position while removing the saw blade (15) from the spindle.
5. Attach appropriate saw blade (15) for the intended use. Ensure that the rotational
direction indicated on the saw blade is the same as the one shown on the housing
and the blade bore fits to the backing flange (16) properly.
6. Carefully move the retraction lever (17) back to its initial position to close the lower
guard (11).
7. Secure the saw blade (15) with the locking flange (14) and locking bolt (incl. spring
and washer) (13). Tighten the locking bolt (13) clockwise with the hex key (24)
provided while pressing the spindle lock lever (5).
8. Turn the saw blade (15) by hand to test if it is rotating smoothly. The blade should
not flutter.
9. Switch the product on and let it run idle for about one minute to ensure that the saw
blade has been installed properly. If there is any abnormal vibration or excessive
noise switch the product off and re-fit the saw blade (15) according to the above
instructions.
03
Parallel guide (Fig. B)
Attach the parallel guide from the right side to perform cuts parallel to the workpiece
edges.
1. Loosen the parallel guide fixation knob (7) anticlockwise.
2. Align the parallel guide (10) to the mounting holes of base plate (8) and insert it.
3. Use the scale on the parallel guide (10a) to adjust the desired width.
4. Fix the parallel guide (10) in position by tightening the parallel guide fixation knob
(7) clockwise.
04
Dust extraction (Fig. C)
WARNING! Attach a dust extraction device when using this product to
help to keep the working area clean! Wear a dust mask when operating
this product! Dust can be harmful to health!
Attach a proper dust extraction device, e.g. a suitable vacuum cleaner attachment
(Ø35mm) to the vacuum cleaner adaptor (1) and then attach to dust extraction outlet
(2).
1400W circular saw MNL_ECS1400_TPS_GB_V1_V20518_20180605.indd 27 6/5/18 3:24 PM