Can Pressure Input Module (CPIM)
The CPIM is responsible for processing the information sent from the pressure sensors.
Accidentally swapping the pressure sensor connections will
not damage system and can be determined if the display is
showing a negative load.
Do not plug the pressure sensor cable into the far right side
boom cable. This will damage the system.
Step
Description
Diagram
1.
Drill and tap two M8 holes for the
CPIM bracket in the side of the
chassis.
Mount using the supplied M8 x
12mm bolts and washers.
2.
Connect the cables for the pressure
sensors and boom cable to the CPIM
as described on the label.
Note: The CCIM cable will be
installed during External Cable
Completion on page 30.
Table 11: Can Pressure Input Module (CPIM) Installation
29 of 53
Summary of Contents for Gen-3 LMS
Page 5: ...Appendix B Reattach Ferrites 51 Indexes and Tables 52 VER 1805241756 5 of 53...
Page 9: ...Illustration 1 Machine Boom VER 1805241756 9 of 53...
Page 10: ...Illustration 2 Machine Chassis VER 1805241756 10 of 53...
Page 43: ...Complete the system checklist once installation has been completed VER 1805241756 43 of 53...
