46
47
(available for download in the „Downloads“ area of the
website www .homematic .com) .
8 Operation
After teaching-in has been performed, simple
operations are available via the taught-in HomeMatic
device . Via the taught-in device (e .g . remote control),
you can switch on and off the switching actuator with
one button (toggle function) or two buttons .
9 Resetting to the initial state
To reset the actuator to the initial state, proceed as
follows:
• Put the device into teach-in mode using the first
channel button (hold it down for at least four
seconds) .
• If the device is in teach-in mode, hold the first
channel button down for at least four seconds again .
If the device LED flashes quickly, this indicates that
the actuator is being reset .
10 Device LED feedback
10.1 Flashing codes
Various actuator states are indicated by the channel
LEDs flashing:
Flash code
Feedback
Short flashing
Teach mode
Fast flashing
Reset
1 x long, 1 x short
Transmit limit (duty
cycle) reached
1 x long, 2 x short
Device defective
10.2 Operating status display
As soon as a channel’s relay is picked up (i .e .
switched on), the corresponding channel LED lights up
continuously .
Once the actuator has been configured via the central
control unit or a programming tool, the device LED
will indicate other device states in addition to those
already described .
