QuadroM-E1/T1 Manual I: Installation Guide
Configuring the QuadroM-E1/T1
QuadroM-E1/T1; (SW Version 5.2.x)
37
Fig. I-35: CAS Signaling Wizard - Receive Signal Settings page
•
Partial Enable – selection partially enables Group B Support with for answer rec-
ognition only. This selection requires you to define transmit and receive signals. The
Transmit Answer Signal parameter is defined from the drop down list on this page.
When transmit signal is selected, press Next on this page to access the R2 Receive
Signal Settings page where Receive Answer Signal should be defined. Use the
checkboxes to select the Receive Answer Signal value. Multiple values are allowed
for each signal.
•
Disable – selection disables Group B Support and requires defining the Answer
Signal parameter.
Setting up Call Routing
The Call Routing service allows you to specify the communication structure between all in-
volved devices by developing a dialing plan and setting the call routing paths accordingly.
For the Quadro extension users, the call procedure should be simple and familiar for all
kinds of calls (internal, SIP, H.323, PSTN or IP-PSTN).
The possibilities Call Routing offers are numerous. The following configuration just a single
example used to explain setup of the QuadroM-E1/T1 as a gateway:
In this example, the QuadroM-E1/T1 is connected within a protected Private Data Network
built of two other Quadro devices (-2x and -4x) where 6 extensions are connected. Each ex-
tension will be configured such that they all shall reach each other and the PSTN. The ex-
tensions also shall be reached by calls from the PSTN.
Summary of Contents for QuadroM-E1
Page 1: ......
