QuadroM-E1/T1 Manual I: Installation Guide
Configuring the QuadroM-E1/T1
QuadroM-E1/T1; (SW Version 5.2.x)
25
Signaling Type CCS
Fig. I-26: Trunk T1 Signaling Type CCS page
If you selected CCS as your Signaling Type, using the Trunk link will take you to the page
shown above. Here you can specify the signaling settings in more detail. Further, this page
allows selection of the timeslots for signaling data and voice.
The Non Automat checkbox switches to non-automatic Terminal Endpoint Identifier (TEI)
searching and enables the TEI Address text field that requires a TEI number (digit values
from 0 to 63) for connection establishment between CO and E1/T1 client. In automatic
mode, an E1/T1 connection will be established on the first available TEI, while in non-
automatic mode a specific TEI may be reserved for the connection. In this case both call
partners need to specify the same TEI in their settings.
In the Network Mode (PBX connected) you need to specify the same TEI address on both
sides (Quadro and PBX), if the Non Automat mode is selected. If the Automat mode is se-
lected the user on the PBX side may set any mode related to TEI assignment in the PBX
configuration.
In the User Mode (CO/PSTN connected) the TEI assignment depends on the CO/PSTN set-
tings. So you have to enter the values you've got from your PSTN provider.
Summary of Contents for QuadroM-E1
Page 1: ......
