QuadroM-E1/T1 Manual I: Installation Guide
Installing QuadroM-E1/T1
QuadroM-E1/T1; (SW Version 5.2.x)
10
Connecting the Hardware
Fig. I-6: Connecting the Hardware
•
Verify the product package contents are complete. Refer to the contents sheet included
in the packaging to determine if all the items were shipped in the box.
•
Connect a telephone to the PHONE port on the QuadroM-E1/T1’s rear panel.
•
Connect the QuadroM-E1/T1’s E1/T1 port(s) to your PBX or the trunk from the
PSTN Central Office ONLY after configuring the E1/T1 settings according to the
specifications of your PSTN provider (see
Appendix: Pin Assignment of E1/T1
).
There might be one or two E1/T1 ports on the QuadroM-E1/T1 depending on the device
model.
•
Connect the Ethernet port on your PC via a straight CAT 5 cable with an RJ-45 connec-
tor to the LAN socket of the QuadroM-E1/T1. If a hub or switch is connected between
the QuadroM-E1/T1 and your PC, use a crossover cable from the LAN interface of the
the WAN port of the QuadroM-E1/T1 to the Private Data Network or Internet
ill glow for several minutes. As soon as Info is off, the QuadroM-E1/T1 is opera-
•
QuadroM-E1/T1 to the hub/switch.
•
Connect
service.
•
When using a DSL or Cable modem, power up the modem before the Quadro.
•
Connect the power adapter to the POWER port on the QuadroM-E1/T1’s rear panel and
plug the power adapter into a power outlet. Only use the original power adapter and plug
it into a power strip with surge protection or to a UPS if available.
The red LED (Fault) will glow for several seconds followed by the yellow LED (Info),
which w
tional.
Power up any hub or switch followed by any PC and other devices on the LAN side.
Please Note:
The PC must be configured for DHCP to receive an IP address directly
from the QuadroM-E1/T1. Refer to
Appendix: PC DHCP Settings
for instructions on how
to set up a PC for DHCP operation.
•
Check the LEDs: The green Busy LED should glow continuously. The green LAN and
WAN LEDs will blink when cables are connected to these ports and all devices are pow-
ered up. If the green LAN and WAN LEDs do not blink, verify cabling and ensure that all
devices are powered up.
Please Note
: CAT 5 cables can be faulty without visual indication. The LAN and WAN
LEDs verify that the Ethernet connection is established between the end points. If these
LEDs are not illuminated, there is a connection problem between the QuadroM-E1/T1
and the other device. Some modems, hubs, switches and routers will require the use of
crossover cables.
Summary of Contents for QuadroM-E1
Page 1: ......
