255
❏
The
Auto
switch on the auto take-up reel unit may not be
positioned for the direction you want. Select a direction using
the
Auto
switch on the control box. See “Taking-up your
❏
If the
Sensor
light flashes slowly when you are not printing,
there may be an external obstruction between the emitter and
detector, or sensor adjustment may not be set properly. Check
for an obstruction in the sensor detection area, or adjust the
sensor position. See “Adjusting the sensor”.
❏
If the
Sensor
light is still flashing, the printer will print the job
for approximately three meters and stop printing. Set the
paper lever to the released position, then check that the roll
paper is set properly and that there is no external obstruction
in the sensor detection area. If the roll paper is not set
properly, wind the excess paper up and set the paper lever to
the secured position.
❏
If the
Sensor
light is flashing rapidly, the auto take-up reel
unit is locked. Turn the printer OFF and ON again.
❏
If the
Sensor
light is off, the sensor cable may not be connected
properly. Check the connection of the sensor cables.
