Epson Stylus Photo Printer PX800FW, Service Manual

Page: 140 / 259

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
DISASSEMBLY/ASSEMBLY Disassembly Procedures 141
Confidential
3. Lift the CDR Tray Assy on the side with arms, remove the CDR Tray Assy to
the rear side of the printer.
Figure 4-95. Remove the CDR Tray Assy (2)
C A U T I O N
Take care not to damage the CDR Tray Sensor when removing the
CDR Tray Assy. (See
Fig. 4-94 , Fig. 4-95 .)
Rear side
CDR Tray Assy
Left arm
Right arm
Dowel on right arm
Groove on CDR Guide
CDR Tray
Sensor
„ Make sure to insert the dowel of the right arm into the groove
on the CDR Guide. (See
Fig. 4-95 .)
„
Place the left arm over the right arm before installation. (See
Fig. 4-95 .)
„ If an arm comes off, place it to the CDR Tray at an angle as
shown in
Fig. 4-96 , and insert the hole of the arm into the hook
on the tray, then rotate it in the direction of the arrow to engage
the arm to the tray.
Figure 4-96. Reassembling the CDR Tray Assy
„ When installing the Spur Gear B, engage its teeth with the
grooves on the CDR Tray Assy. (See
Fig. 4-94 .)
A D J U S T M E N T
R E Q U I R E D
„ After replacing the CDR Tray Assy, make the specified
adjustments. (See
Chapter 5 "ADJUSTMENT" .)
„ When replacing the CDR Tray Assy, make sure to carry out
the specified lubrication. (See
Chapter 6 "MAINTENANCE" .)
Hole & hook
CDR Tray Assy
http://www.manuals4you.com