Epson Stylus Color, Service Manual

Page: 89 / 151

EPSON Stylus Photo
Rev. A
3-20
3.2.5.5.1 ASF Disassembly
1. Removing the ASF. (Refer to section 3.2.5.5)
2. Remove “TWIST SPRING, 41.2” by unhooking one end from the ASF frame and remove “LEVER,
BRAKE”.
3. Remove “BUSH, FIXING, SHAFT” from the right end of “SHAFT, ROLLER, LD” and remove “LEVER,
HOPPER, RELEASE”.
4. Move the left paper pick-up assembly to the middle of the ASF and remove “BUSH” from the shaft.
5. Push out “SHAFT, ROLLER, LD” to the left and remove “BUSH, FIXING, SHAFT, LEFT” from the left-
end of the shaft by unhook it.
6. Unhook the top of “HOPPER, ASSEMBLY” from the both sides of “FRAME, ASF”.
7. Push out “SHAFT, ROLLER, LD” to the right while pulling up “PICKUP, ROLLER ASSEMBLY, RIGHT”
slightly. Then, detach the left end of “SHAFT, ROLLER, LD” from “FRAME, ASF”.
8. Holds “HOPPER, ASSEMBLY” and remove the right cam part of “HOPPER, ASSEMBLY” through the
hole at the right side of “FRAME, ASF”.
To this point, the ASF assembly is disassembled and both left and right “PICKUP, ROLLER ASSEMBLY”
and “HOPPER, ASSEMBLY” are separated.
WORK POINT
When removing “HOPPER, ASSEMBLY”, be careful that the grease that applied to the cam part
of it, not to attach to the other part of the ASF. If so, wipe it off completely.
Be careful of the direction when you install the “LEVER, HOPPER, RELEASE”.
Make sure that bushes at the both ends of the shaft are firmly attached.
HOPPER, ASSEMBLY
LEVER, BRAKE
TWIST SPRING, 41.2
BUSH, FIXING, SHAFT, LEFT
FRAME, ASF
LEVER, HOPPER, RELEASE
BUSH, FIXING, SHAFT SHAFT, ROLLER, LD
BUSH
CAM part
Figure 3-17. ASF Disassembly