Epson RX580 - Stylus Photo Color Inkjet, Service Manual

Page: 66 / 107

EPSON Stylus PHOTO RX560/580/590 Revision A
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 66
4.5.5 CR Motor
1. Remove the Printer Mechanism (p.55)
2. Remove the I/S Assy (p.63)
3. Remove the ASF Assy (p.64)
4. At the rear of the printer, disconnect the harness of the CR Motor from the frame.
5. At the rear of the printer, remove the tension spring of the Driven Pulley Assy.
(Fig. 4-67)
6. Remove the screws (x2), and remove the CR Motor. (Fig. 4-68 )
Figure 4-66. Removing the CR Motor Harness
Figure 4-67. Removing the Tension Spring
Figure 4-68. Removing the CR Motor
„
Lubrication is necessary. Refer to the following section and
lubricate the specified points:
LUBRICATION OF DRIVEN PULLEY (p.91)
„
Install the CR Motor with its printed area facing upward.
„
Install the Timing Belt with the tooth side facing inside and
without torsion.
„
When the CR Motor has been replaced with a new one, wind
acetate tape (18x20 mm) x4 around the harness as shown.
(Fig.
4-66)
A D J U S T M E N T
R E Q U I R E D
Once the CR Motor has been reinstalled, refer to the following
section and perform the necessary adjustments.
„
5.1.1 Adjustment by Use of Adjustment Program (p.74 )
Acetate Tape (18x30mm)
Hook (x3)
Acetate Tape (18x20mm) x4
10 mm
1 cm away from the end of the tape wound around the harness
Driven Pulley Assy
Tension Spring
C.P 3x4 (x2)
Torque : 0.4±0.1N
·
m