Epson RX580 - Stylus Photo Color Inkjet, Service Manual

Page: 58 / 107

EPSON Stylus PHOTO RX560/580/590 Revision A
Disassembly and Assembly Disassembly of Housing Lower Assy 58
Figure 4-44. Installing the CD-R Shaft
Figure 4-45. Installing the Stacker
Figure 4-46. Installing the CD-R Guide Lever Spring
„
When installing the CD-R Shaft, orient it so that the side where the
distance from the shaft end to the hole for the hook of the gear is
larger is positioned left (on the spring side), and pass it through the
Stacker.
(Fig. 4-44)
„
Before tightening the screws, confirm the following conditions:
♦
Right and Left Stacker Guides have been installed properly.
(Check the 2 locating holes and 1 projection)
♦
Stacker has been installed properly. (Check the following
positions with the Stacker in the down position.) (Fig. 4-45)
• Projections (x2) in the rear (under the Stacker Guides)
• Protrusions at right and left sides (inserted in guide groove)
„
Tighten the screws in the specified order. (Fig. 4-42)
„
See Fig.4-46 for installation of the CD-R Guide Lever Spring.
C H E C K
P O I N T
If the Stacker is not horizontal in the right and left direction,
remove the right gear, and install the gear again with the Stacker
in the highest position.
Install the gear with the shaft
in the highest position
Hook hole
Hook hole
CD-R Shaft Longer side positioned left
Insert the protrusion
into the guide groove
Insert the projection under the guide
Stacker is in the down position
1.Put the ring on the shaft
2.Insert the hook end into the guide
3.Push the ring onto the gear
After installing the spring, move Stacker up and down and check the installation of the spring.
~Down~ ~Up~