Epson RX580 - Stylus Photo Color Inkjet, Service Manual

Page: 42 / 107

EPSON Stylus PHOTO RX560/580/590 Revision A
Disassembly and Assembly Removal of Exterior Parts 42
4.2 Removal of Exterior Parts
4.2.1 Panel Assy
1. Open the Scanner Unit, and remove the screws (x3) securing the Middle Cover
Assy.
(Fig. 4-1)
2. Release the hooks (marked with
∆
: x4) on the side of the Printer Mechanism to let
the Middle Cover rise, insert a bamboo spatulas whose tip is soft into the cut
portion at the front center to release the hook, and remove the Middle Cover Assy.
3. Release the hooks at the right and left ends from the direction of the back of the
panel to let the decorative panel rise, release all the hooks carefully and remove the
decorative panel.
4. Remove the screws (x2) securing the Panel Assy. (Fig. 4-2)
5. Lift the Panel Assy, and disconnect the FFCs x2 (CN23 and CN22) from the Main
Board.
(Fig. 4-3)
Figure 4-1. Removing the Middle Cover Assy
Figure 4-2. Removing the Decorative Panel and Panel Assy
Figure 4-3. Removing the Panel Assy 2
C A U T I O N
After removing the decorative panel, take care that the LCD
surface is kept free from scratches or dust and dirt.
When installing the decorative panel, observe the following
instructions:
„
Make certain that the back of the panel window and the LCD
face are free from dust and dirt.
„
Stick a new strip of double-stick tape in the position shown
below and after installing the decorative panel, make sure that
it is stuck securely and free from floating.
15 ± 1 mm
4
± 1
m
m
Double-stick tape, 20 x 5
Before sticking the
double-stick tape, clean
with alcohol the surfaces
of the printer body and
the panel where the tape
is to be stuck.
After installing the panel,
press on it so that the tape
is stuck securely and the
panel does not float.
C.B.P-TITE 3x10 (x3)
Torque : 0.6±0.1N · m
Hook (x3)
Hook (x4)
Middle Cover Assy
Unhook
C.B.P-TITE 3x10 (x2)
Torque : 0.6±0.1N
·
m
Decorative panel
Unhook
CN23
CN22
Double-stick tape