Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEET
NEXT
B
RP-U420 series
Specification
(STANDARD)
4
3
1.7 Stamp
•
The standard model provides a stamp mechanism.
•
The stamp material must be provided by the user.
•
A stamp frame can be provided as an option.
1) Material:
Porous rubber
2) Stamp face dimensions:
30(W)
×
20(H)mm
NOTE: Stamp face characters should be equal in the area both above and below the
centerline.(When the difference is extreme, part of characters may not print.)
3) Recommended stamp model
Shachihata XS-20
Fujicopian CSP-2030D
4) Recommended ink
Shachihata Y-34
Fujicopian Super Ink (purple)
NOTES: 1. Because the stamp is located near the paper exit slot of the paper feed mechanism, the
knurled screw of the paper holder may become stained when replacing the stamp or
refilling ink.
2. To refill ink, inject 2-3 drops through each round hole in the rear of the stamp set.
3. After refilling ink, leave the unit upturned until the ink has fully spread (3 hours is
recommended time).
4. Use only the recommended ink to prevent leaks during and after refilling.
5. Do not change from using refill ink made by one manufacturer to ink made by another
manufacturer.
5) Stamp button:
Installed as a standard
Refer to Section 3.3.3 in detail.
1.8 Buzzer
A buzzer is installed.
The buzzer cannot sound if DIP SW2-3 is set to Off. (See Table 3.3.2 for the DIP SW2)
The conditions when the buzzer beeps are as follows if DIP SW2-3 is set to On.
•
When an error occurs.
•
When the DLE ENQ command is executed.
•
When the ESC @ command is executed.
•
When the self-test is executed (See Section 3.6, Self-test).
•
When the hexadecimal dump is executed (See Section 3.7, Hexadecimal Dump).
