113
Publishing Discs
3
Insert the stacker, and close the disc cover.
•
Directly touching or moisture getting on the label surface before or after printing may
result in blurring or discs sticking together.
•
After printing on the label surface, allow Epson specified discs to dry for at least one hour,
and other types of discs for at least 24 hours. Do not insert discs into a drive or other device
until they are completely dry.
•
Avoid drying under direct sunlight.
•
When discs are published in Batch Mode, the number of discs loaded into Stacker 2 and the
number of discs output to Stacker 3 do not always match. Also, 50 discs may not be output.
The same applies for the discs output to Stacker 2.
In Batch Mode, once the height of the stack of discs output to Stacker 3 reaches the
maximum value, the output stacker is switched to Stacker 2. Therefore, the number of discs
output to a stacker differs depending on the thickness of the discs used.
•
Stacker 4 holds up to approximately five discs. Once Stacker 4 becomes full, the job is
paused. The job is resumed automatically if you take out the published discs from Stacker 4.
•
You can take out the published discs output to Stacker 4 without pausing the job.
