122
LCD screen message
Condition/solution
Recovery mode
An error has occurred during firmware updating. Connect the AC adapter to
the product and connect the product to your computer using a USB cable,
then try updating the firmware again. If you still see this error message,
contact Epson for support.
Note:
The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages.
During the life of your product it may reach a condition where either satisfactory print quality cannot be
maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your
LCD screen, or lights on the control panel will advise you when these parts need replacing. If this
happens during the standard warranty of the product, the exchange of the product or replacement of the
pads is covered under the standard warranty. If the product is out of warranty, the pads can be replaced
by any Epson authorized service provider. The waste ink pads are not a user-replaceable part.
Parent topic:
Related references
Paper Jam Problems Inside the Product
Where to Get Help
Related tasks
Selecting the Paper Settings - Control Panel
Accessing the Web Config Utility
Related topics
Replacing the Ink Cartridge and Maintenance Box
Using the Optional Battery
Solving Network Problems
Running a Product Check
Running a product check helps you determine if your product is operating properly.
1.
Disconnect any interface cables connected to your product.
2.
Load paper in this size in your product: 3.5 × 5 inches (89 × 127 mm) or larger.
3.
Press the
home button, if necessary.
4.
Press the arrow buttons to select
Setup
and press the
OK
button.
5.
Select
Maintenance
and press the
OK
button.