Switching back to single sheets
To switch to single sheets, press the
Load/Eject
button; the printer feeds the paper backwards into the standby position.
.
Caution:
Always tear off your printed document before you press the
Load/Eject
button. Reverse feeding several
pages at a time may cause a paper jam.
Adjusting the top-of-form position
The top-of-form position is the position on the page where the printer starts printing. If your printing appears too high or low
on the page, you can use the micro adjust feature to adjust the top-of-form position. Follow these steps:
Caution:
Never use the paper feed knob to adjust the top-of-form position; this may damage the printer or cause it to
lose the top-of-form position.
Note:
Your top-of-form position setting remains in effect until you change it, even if you turn off the printer.
The top margin setting made in some application software overrides the top-of-form position setting
you make with the Micro Adjust feature. If necessary, adjust the top-of-form position in your software.
Make sure the printer is turned on.
If necessary, load paper as described in this chapter.
Remove the printer cover.
Hold down the
Pause
button for about three seconds. The
Pause
light starts flashing and the printer enters the Micro
Adjust mode.
Press the
LF/FF
button to move the top-of-form position down on the page, or press the
Load/Eject
button to
move the top-of-form position up on the page.
* plastic ribbon cover
Note:
