Formatting Diskettes
Before you can store data on a new diskette, the diskette
must be formatted. Formatting prepares the diskette so
MS-DOS can write to it. You need to do this only once,
before you use the diskette for the first time.
You can also reformat previously used diskettes.
Reformatting, however, erases all data on that diskette. Always
be sure that you do not want to save any of the data on a
used diskette before you format it.
The formatting procedure you use depends on the
configuration of your system:
l
Two diskette drives
l
One diskette drive (and one hard disk).
Follow the instructions below for your system.
Formatting with two diskette drives
Follow this procedure to format a diskette in drive B. The
drive can be either the internal drive on the left side of the
computer or an external 5 -inch diskette drive.
1. Insert your working copy of the MS-DOS system diskette
in drive A (and press any key if necessary).
2. When you see the A> prompt, type:
FORMAT B:
and press
Enter.
You see this prompt:
Insert new diskette for drive B:
and strike ENTER when ready
3. Insert the diskette you want to format into drive B, and
press
Enter
to start formatting. MS-DOS displays the head
and cylinder numbers as it formats each cylinder of the
diskette.
4-6
Using MS-DOS With the Equity LT
Summary of Contents for Equity LT
Page 1: ...EQUlTY LT User s Guide Y16499100301 ...
Page 4: ...EPSON Equity LT User s Guide ...
Page 7: ...User s Guide ...
Page 149: ......
