When the computer is running at 4.77 MHz, the power
LED is orange. At 10 MHz, the light is green.
Resetting the Computer
You can reset the computer to reload the operating system
or to restart a program. You may also need to reset if an error
occurs and the computer does not respond to anything you
type. Resetting, however, erases any data in the computer’s
temporary memory (RAM) that you have not stored; so be
careful when you reset your computer.
In MS-DOS, you can hold down
Ctrl
and press C to stop
a program’s operation and return to the MS-DOS command
prompt. If an error occurs, try this method before you reset the
computer.
WARNING
Do not reset the computer to exit a program unless you have
to. Some application programs classify and store new data
whenever you exit the program properly. If you reset the
computer while such a program is running, you may lose data.
There are three ways to reset. Because each is more
powerful than the last, try them in the order listed here:
1. If you are using MS-DOS, hold down
Ctrl
and
Alt
and
press the
Del
key on the numeric keypad at the right of
the keyboard. The screen goes blank for a moment and
then MS-DOS reloads. (MS-DOS must either be on the
diskette in drive A or on the hard disk.) If this does not
correct the problem, try the second method.
2. Use a pencil or a similar type of thin pointed object to
press the
RESET
button above the keyboard. This method
works even when the keyboard does not respond to your
commands. If this does not correct the problem, try the
third method.
3-6
Using the Equity LT
Summary of Contents for Equity LT
Page 1: ...EQUlTY LT User s Guide Y16499100301 ...
Page 4: ...EPSON Equity LT User s Guide ...
Page 7: ...User s Guide ...
Page 149: ......
