5.
Push the SIMM into the socket until it is seated firmly in the
slot. Then tilt it upright, as shown below, guiding the hole
at each end of the SIMM over the retaining post at each end
of the SIMM socket. If it does not go in smoothly, do not
force it; pull it all the way out and try again.
6.
Replace any option cards you removed. (See page 4-14 for
instructions.)
Removing SIMMs
If you need to remove SIMMs from your computer (to install
different ones, for example), make sure the computer is turned
off and then follow the steps below:
1.
Make sure the front of the computer is facing you.
2.
Refer to the illustration on page 4-5 to locate the SIMM
sockets on the right side of the system board.
3.
Remove any option cards that may be blocking your access
to the SIMM sockets. (See page 4-18 for instructions.)
4-12
Installing and Removing Options
Summary of Contents for EL 486UC+
