Troubleshooting
82
The settings cannot be modified using the remote controller function for Epson iProjection.
Check
Remedy
Is the connected network device turned on?
When the projector is in the standby mode with
Standby
Mode
set to
Communication On
, check to see if the connected
network device is powered on. After powering on the network
device, try starting the projector again.
s
Extended
-
Standby
Mode
The image contains static during network projection
Check
Remedy
Are there any obstacles between the access
point and the connected device?
Check for any obstacles between the access point, the mobile
device, the computer, and the projector, and change their posi-
tions to improve communication.
Is the distance between the access point and
the connected device too far?
Make sure that the access point, the mobile device, the comput-
er, and the projector are not too far apart. Move them closer to-
gether and try to connect again.
Are there any Bluetooth devices or micro-
wave oven in the vicinity?
If the wireless connection is slow or your projected image con-
tains noise, check for interference from other equipment, such
as a Bluetooth device or microwave. Move the interfering device
farther away or expand your wireless bandwidth.
Are too many devices connected?
Reduce the number of connected devices if the connection
speed declines.
About Event ID
Check the event ID and perform the remedy given below. If you cannot resolve the problem, contact your
local dealer or the nearest Epson repair center.
s
Event ID
Cause
Remedy
0022
0027
0028
0029
0030
0031
0035
0434
0481
0482
0485
Network communication is unstable.
Check the network communication status, and
reconnect after waiting for a while.
0432
0435
Failed to start the network software.
Restart the projector.
0433
An image that was transferred cannot be re-
produced.
Restart the network software.
0484
Communications was cut off from the comput-
er.
