Troubleshooting
80
Check
Remedy
Is
3D Display
set to
2D
?
If
3D Display
is set to
2D
from the Configuration menu, the pro-
jector does not automatically change to 3D even when a 3D im-
age is input. Set
3D Display
to either
3D
or
Auto
.
s
Signal
-
3D
Setup
-
3D Display
Is
3D Format
set correctly?
Unless the 3D format of the AV device and
3D Format
of the
projector are the same, part of the image may not be displayed.
Check that the projector's
3D Format
setting matches the 3D
format setting for the AV device.
s
Signal
-
3D Setup
-
3D For-
mat
When changing the
3D Format
, set
3D Display
to
3D
, and then
press the [3D Format] button.
Are you viewing within the reception range? If the distance between the projector and the 3D Glasses exceed
10 m, the connection may be lost. Move the 3D Glasses closer to
the projector.
Has pairing been performed correctly?
See the user's guide supplied with your 3D Glasses and perform
pairing.
Are there any devices that cause radio wave
interference in the vicinity?
When using other devices at the same time with the frequency
band (2.4 GHz) such as Bluetooth communication devices, wire-
less LAN (IEEE802.11b/g), or microwave ovens, radio wave inter-
ference may occur, the image may be interrupted, or communi-
cation may not be possible. Do not use the projector near these
devices.
Problems with HDMI
HDMI Link does not function
Check
Remedy
Are you using a cable that meets the HDMI
standards?
Operations are not possible with cables that do not meet the
HDMI standards.
Does the connected device meet the HDMI
CEC standards?
If the connected device does not meet the HDMI CEC standards,
it cannot be operated even if it is connected to the HDMI port.
See the documentation and so on supplied with the connected
device for more information.
Also, press the [HDMI Link] button, and then check if the device
is available under
Device Connections
.
s
Are the cables connected correctly?
Check that all the cables required to use HDMI Link are securely
connected.
s
Is the power for the amplifier or DVD recorder
and so on turned on?
Put each device in standby status. See the documentation and
so on supplied with the connected device for more information.
If you have connected a speaker and so on, set the connected
equipment to PCM output.
Was a new device connected, or was the con-
nection changed?
If the CEC function for a connected device needs to be set again,
for example when a new device is connected or the connection
is changed, you may need to restart the device.
Are many multi-media players connected?
Up to 2 multi-media players that meet the HDMI CEC standards
can be connected at the same time.
