Epson EB-4550, Installation Manual

Page: 21 / 91

Each time you press one of the buttons, the angle of tilt changes by 15
degrees. Set as close to the actual setup angle as possible.
90
45
0
135
180
-135
-90
-45
Base
When you have finished making settings, use the [ ] button to select Set ,
and then press the [ ] button.
Attention
Make sure you set Direction correctly. The lamp's operating life may be
reduced if it is not set.
Changing the direction of the image (projection mode)
You can change the direction of the image using Projection mode from the
Configuration menu.
Press [Menu] button > Extended > Projection
When Front is the standard, the image directions for each projection mode
are as follows.
Front (default) Front/Ceiling
Rear Rear/Ceiling
a
•
You can change the setting as follows by pressing down the [A/V
Mute] button on the remote control for about five seconds.
Front
W
Front/Ceiling
•
Make sure you check the Direction setting when you change the
projector's installation position.
Press [Menu] button >
Extended > Direction
Installing the Projector
21