Orchis
booklet.fm
Rev. A
A5-Format
Lq680Booklet_E.fm
9/18/00
Durchlauf 2
L
Proof-Abzeichnung:
M. Hida, CRE Tsukada_______
N.Nomoto
_______
K.Norum
_______
4
Important Safety Instructions
■
Important Safety Instructions
Read all of these instructions and save them for later reference. Follow all warnings
and instructions marked on the printer.
■
Do not place the printer on an unstable surface or near a radiator or heat source.
■
Place the printer on a flat surface. The printer will not operate properly if it is tilted
or at an angle.
■
Do not block or cover the openings in the printer’s cabinet. Do not insert objects
through the slots.
■
Use only the type of power source indicated on the printer’s label.
■
Connect all equipment to properly grounded power outlets. Avoid using outlets on
the same circuit as photocopiers or air control systems that regularly switch on and
off.
■
Do not use a damaged or frayed power cord.
■
If you use an extension cord with the printer, make sure the total ampere rating of
all devices plugged into the extension cord does not exceed the cord’s ampere rating.
Also, make sure the total of all devices plugged into the wall outlet does not exceed
the wall outlet’s ampere rating.
■
Unplug the printer before cleaning, and clean it with a damp cloth only.
■
Do not spill liquid on the printer.
■
Except as specifically explained in this guide, do not attempt to service the printer
yourself.
■
Unplug the printer and refer servicing to qualified personnel under the following
conditions:
If the power cord or plug is damaged; if liquid has entered the printer; if the printer
has been dropped or the cabinet damaged; or if the printer does not operate normally
or exhibits a distinct change in performance. Adjust only those controls that are
covered by the operating instructions.
■
Printer parts marked with this symbol may be hot. Turn off the
printer and let it cool for a few minutes before you touch any printer
part marked with this symbol.
■
If you plan to use the printer in Germany, observe the following:
To provide adequate short-circuit protection and over-current protection for this
printer, the building installation must be protected by a 10 or 16 amp circuit breaker.
K
