Edge Power Solutions
EPS-32-V1 / EPS-32-V2 / EPS-16 Installation Manual Revision 7.0 05102020
2.6
Connecting Outputs to Field Devices:
2.6.1
Insert Phoenix Interface Connectors
•
Insert 16 position male Phoenix connector into matching 16 position female Phoenix interface on front face of the
chassis
•
The Connector will fit tightly into the interface. Tighten retainer screws with light torque if desired.
•
If Connector removal is required use care to avoid bending the pins of the receiving connector.
2.6.2
Insert Optional 2 port Phoenix Connectors
•
Insert optional 2 position male Phoenix connector into matching 16 position female Phoenix interface on front face of
the chassis.
•
Observe proper polarity when terminating connector.
o
With the screw at the top the negative terminal is on the left the positive terminal is on the right.
•
Fill in all unused positions with 2 position connectors to avoid leaving exposed pins
•
If Connector removal is required use care to avoid bending the pins of the receiving connector.
PAGE 6
