Edge Power Solutions
EPS-32-V1 / EPS-32-V2 / EPS-16 Installation Manual Revision 7.0 05102020
2.7
Connect Remote Device Power Cables
•
Observing proper polarity, connect remote device power cables.
o
Acceptable wire sizes: 12AWG – 24AWG
Choose appropriate AWG of wire based on Current, Distance & Acceptable Voltage Drop.
Consult with connecting device manufacturer for device requirements
o
Recommended strip length: ¼”
•
Tighten screw above input until cable is secure.
2.8
Connecting AC Power
SEE NOTE 1 / PAGE 1
•
Connected provided cord to AC input on rear of chassis
o
Units can accept up to 240VAC with appropriate cable
•
Push adjacent power switch(es) to the On/Reset Position when ready to power on unit and connected devices
o
Turn on CB1 (EPS-16 & EPS-32-V2)
o
Turn on CB1 & CB2 (EPS-32-V1)
•
The power switch(es) will light up in off position to indicate the AC power source outlet is properly grounded.
PAGE 7