ePropulsion Pod Drive 1.0 Evo, User Manual, Page: 19 / 48

17
Pod Drive 3.0 & 6.0 Evo:
Step 3:
Check the three phase lines U-U1, V-V1, W-W1, put the three phase lines into
the phase line clamp; fix the terminal on the driver with the hexagon screw M10 and
washer (tightening torque 8 -10Nm); finally insert the temperature line into the corre
-
sponding connector and tighten it.
Please check the U V W connection is correct, otherwise it may cause the motor
to reverse.
Figure 3-6
Step 4: Place the driver module on the proper position on the board and fix it with M8
screws (refer to figure 3-8 for the fixing holes).
Figure 3-7
U/V/ W icon
U1/V1/W icon
Phase line clamp
Connector
M8x14 screw 、 M8 washer
Temperature Line
M8 Screws