20
3.3 Connecting Battery to Motor
Flip the SUP/kayak, etc. over after the motor module is firmly installed on
the bottom. Plug the motor cable connector into the charge/discharge port of
the LAGOON Battery and tighten the connector. Fix the power cable with a
Velcro tape.
Fix the power cable on the
SUP with a Velcro tape
Plug the power cable into
the charge/discharge port
Figure 3-11
Pay attention not to hit the thruster against the ground or other objects
while flipping the SUP/kayak, etc.
3.4 Attaching LAGOON Remote Control
LAGOON Remote Control can be attached to a paddle or wrist for easy
access. You need to penetrate a Velcro tape through the side opening of
LAGOON Remote Control and bind the strap tightly around the wrist or
paddle as shown in Figure 3-12.
Make sure the Velcro tape is tightly bound if you wear it or attach it to a
paddle to avoid it falling into water.
If LAGOON Remote Control falls into water by accident, a wireless
communication failure may occur and LAGOON Motor will stop rotation
at once.
