Product Information
PSC SVC
______________________________________________________________________________
Subject
to
modification
due
to
technical
advance!
95.700.007.D.E
/
2015
‐
04
7
turn eccentric bolt into position
unclamped
(counterclockwise, up to the stop)
slide the PSC-holder into the location hole up to the stop
(distance tool / hole < 0,5 mm)
turn eccentric bolt clockwise up to the stop;
at first, the growing retarding force of the spring can be noticed; then the rotating
motion is briefly without noticeable retarding force; finally the stop is distinctly
noticeable.
The pull-in force is caused by the spring of the clamping unit, not by the tightening
torque of the eccentric bolt.
4 Operation
Always consider the following points:
The manual clamping unit PSC SVC is only designed for static operation -
no rotation allowed!
Only use technically perfect tools!
4.1
Clamp
and
unclamp
Clamp:
Precondition: Area of contact clean and intact
Unclamp:
Recommendation: In case of using the PSC-interface without tool take a filler
plug!
nominal size
32 40 50
tightening torque max. (Nm)
10
20
30
A/F
5 6 8
hold
PSC-holder
turn eccentric bolt into position
unclamped
(counterclockwise, up to the stop)
remove PSC-holder
