BIOS
EP-MVP3C/2
Page 4-14
4-6 Load Setup Defaults
The “LOAD SETUP DEFAULTS” function loads the system default data directly
from ROM and initializes the associated hardware properly. This function will be
necessary only when the system CMOS data is corrupted.
4-7 Integrated Peripherals
Figure 8: Integrated Peripherals
Note: If you do not use the Onboard IDE connector, then you will need to
set Onboard Primary PCI IDE: Disabled and Onboard Secondary PCI
IDE: Disabled
Note: The Onboard PCI IDE cable should be equal to or less than 18
inches (45 cm.).
IDE HDD Block Mode: IDE Block Mode allows the controller to access blocks
of sectors rather than a single sector at a time.
The default is Enabled.
Enabled: Enabled IDE HDD Block Mode. Provides higher HDD
transfer rates.
Disabled: Disable IDE HDD Block Mode.
ROM PCI/ISA BIOS(2A5LEPA9)
INTEGRATED PERIPHERALS
AWARD SOFTWARE, INC.
OnChip IDE Channel0
: Enabled
Onboard Parallel Port
: 378/IRQ7
OnChip IDE Second Channel1
: Enabled
Onboard Parallel Mode
: ECP / EPP
IDE Prefetch Mode
: Enabled
ECP Mode Use DMA
: 3
IDE HDD Block Mode
: Enabled
Parallel Port EPP Type
: EPP1.9
IDE Primary Master PIO
: Auto
OnChip USB
: Enabled
IDE Primary Slave PIO
: Auto
USB Keyboard Support
: Disabled
IDE Secondary Master PIO
: Auto
IDE Secondary Slave PIO
: Auto
IDE Primary Master UDMA
: Auto
IDE Primary Slave UDMA
: Auto
IDE Secondary Master UDMA
: Auto
IDE Secondary Slave UDMA
: Auto
IDE Init Display First
: PCI Slot
Onboard FDD Controller
: Enabled
Onboard Serial Port 1
: 3F8/IRQ4
Onboard Serial Port 2
: 2F8/IRQ3
UART 2 Mode
: Standard
Esc : Quit
: Select Item
F1
: Help
PU/PD/+/- : Modify
F5
: Old Values
(Shift) F2
: Color
F7
: Load Setup Defaults
é
é
é
é
é ê
ê
ê
ê
ê è
è
è
è
è ç
ç
ç
ç
ç