page | 12
www.snapav.com Support 866.838.5052
SETTING UP THE AMPLIFIER POWER MODE
These amplifiers can be set up to automatically power on when needed. There are three Power Mode options
available from the browser user interface: Power Button, Voltage Trigger, and Audio Sense.
To set POWER MODE to Power Button:
1.
Using the browser user interface, set
POWER MODE
to
Power Button
.
Note:
In this mode, the amplifier can be turned on and off with the power button, IP commands, or IR
commands. The amplifier automatically goes into Standby if no audio is sensed for 15 minutes (default).
However, this time setting can be changed, or Standby mode can be disabled. If Standby mode is disabled,
the amplifier turns off only when the front power button is pressed or an IP or IR power command is
received. See “Standby Settings” below for more information.
To set POWER MODE to Voltage Trigger:
1.
Using the browser user interface, set
POWER MODE
to
Voltage Trigger
.
2.
Connect the 4.5V-12V trigger cable from the trigger device to the
TRIG IN
port.
3.
(Optional) Connect the
TRIG OUT
(12V DC) port to another amplifier to link their power controls.
Note:
In this mode, the amplifier turns on or off only when a 4.5V DC-12V DC signal is present or absent on
the
TRIG IN
jack.
www.snapav.com Support 866.838.5052
