page | 10
www.snapav.com Support 866.838.5052
To connect bridged speakers:
1.
Power off the amplifier, then remove the output’s terminal
block.
2.
Connect the
+
terminal from the speaker to the
+
terminal of
the left channel (L) on the amplifier.
3.
Connect the
-
terminal from the speaker to the
–
terminal of
the right channel (R) on the amplifier.
The two terminals for a bridged pair of speakers are marked
by
+ BRIDGE -
.
In bridge mode, both amplifier channels output the same
audio. A mono source can be connected to a bridge input
to create a bridged mono output. Or, a stereo source can be
connected to two bridge inputs (using two zones) to create a
bridged stereo output.
4.
Set the Bridge Mode
ON
through the browser user interface.
USING THE BROWSER USER INTERFACE
1.
Connect an Ethernet Cat5E/6 cable from a local network connection into the RJ45 port on the amplifier.
2.
Power on the amplifier.
3.
In a web browser on the same local network, enter the amplifier’s IP address that was assigned by the router
(such as
192.168.1.2
). The login screen opens.
4.
Enter the default (first-time only) password “
episode
” (the user name is also “
episode
”). The amplifier’s
configuration screen opens.
Note:
The first time you access the interface, or after a reset to factory default settings, you must change the
password.
5.
Set the volume gain through level trim bar.
www.snapav.com Support 866.838.5052
