Epic Red Epic-M, Operation Manual, Page: 197 / 228

Version 3.0
955-0002_v3.0, Rev-B
COPYRIGHT © 2012 Red.com, Inc.
195
-
Slave:
S001_R001_0503R7.R3D
Where 0503 represents 05 March, B6 and R7 are examples of camera generated wildcard characters.
Note: If both Master and Slave cameras are accidentally left in default settings of CENTER and
CAM A ID, the clips recorded on each camera will have the same file structure, with the exception
of the camera generated wildcard characters which protect against exact file name duplication:
-
Master: A001_C001_0503B6.R3D
-
Slave: A001_C001_0503R7.R3D
CONNECTING CAMERAS
1. While still powered up, interconnect the cameras using a Master/Slave GIG-E Cable P/N 790-0163.
Plug the cable into the GIG-E connector on the rear of each camera body..
2. Power down both cameras, then power back up. If properly connected, LAN will illuminate Green on
the UI.
3. Connect a SYNC cable P/N 790-0154 to each camera and connect as to your 3
rd
party device.
•
Yellow BNC connector is for SMPTE unbalanced Timecode input.
•
Green BNC connector is for Tri-Level Sync (Genlock) input.
•
White BNC connector is a dual-purpose (Shutter SYNC input or GPI) input.
4. Go to SETTINGS > SETUP > GPIO/SYNC > SYNC MODE and select GENLOCK.