Epec 4W30, Instructions For Use Manual

Page: 12 / 73

Instructions for use Epec 4W30 11
(C) Epec Oy Seinäjoki Finland
−
The different display items can be selected by rotating the
programming wheel and by pressing ENTER key or CANCEL key.
−
The preselection data can be changed by pressing the preselection
key in question to the bottom, then the frame jumps to the bottom line
and the data to be changed can be selected with the programming
wheel. Data can be changed, provided that the grapple is kept open
during the change.
−
Switching between the different display keys or adjusting the value of
an active adjustment key is done with the programming wheel.
−
The Enter key can be used for instance to open a new display
window or to activate an adjustment key for adjustment. There is a
shading around the active square, i.e. the lower edge and the right
edge of the key are thicker than the other edges.
−
The Cancel key is used for switching between the upper menu and
the other display keys. Cancel is also used for removal of the
activation of an active display key.
−
The Cancel key can also be used for cancellation of a printout. In that
case, the Cancel key must be pressed for appr. 2 seconds.
−
Pressing the Cancel key for 4 seconds in the main display activates
the service mode, where all the parameters can be adjusted. The text
"SERVICE" is displayed on the bottom line of the display, when the
service mode is activated.
Not active display key Active display key (shaded)
Symbol of grapple closed
Flashing indicates that sawing has not been carried out
Symbol of saw in outer position
Upper menu
By pressing the Enter key when the frame is on the symbol,
the display window is changed
Settings / Parameters
Test / Calibration
Pieces made / Printout
Symbol of grapple open