EPE EPS-2000 Series, Owner'S Manual

Page: 38 / 455

Owner’s Manual
The UPS is now in its
Voltage and Current measure
and can
displayed by pressing the V and A
on the See 2.9 for
The EPS-2000’” can be adjusted for the
quirements of your installation if you desire
tings other than the
factory settings
Refer to the Menu 3.3.2.9).
0
2.7.3 Anomalies
During the Start-Up the LCD on your
may indiie:
The AC phases
of is
quested by the EPS Monitor start-up: in
ii. AC
source. To perform this
the UPS must be isolated end
shut by switching off the upstream
breakers supplying to the UPS.
The AC source phases
out of sequence. To correct this condition,
the UPS must be isolated and
break-
er% tha UPS.
Alter performing the required action,
repeat the Initial Start-Up procedure from the
beginning.
2.9 Tests After Start-Up
performing the initial start-up
the following tests should be to in-
sure proper operation of your UPS.
2.9.1 Tests
For of the and see Fig-
11, 1.