EPE EPS-2000 Series, Owner'S Manual

Page: 112 / 455

Uninterruptible Power System
2.4
2.4.2
If the
equipment is to be stored prior to should in a
location that is protected splashing water. chemical etc. The equip-
ment should be with a tarpaulin or wrapper to protect dust. paint,
other foreign
Prerequisites to the
a he
must be handled by and familiar with tie
special requirements 70, issue) and
may be applicable: and the special safety to be taken
and equipment. we EPE Customer Services
for
and stat-up. Do not
unqualified to handle or operate EPS-2000
Environmental
The
is computer similar control
is provided. The maximum
provided in
The generates heat and the top portion of its enclosure. This
added heat must be by the air system. Heat load data is
Table exhaust rate is approximately 1.400 cubic feet per minute
Mechanical
EPS-2000 can be installed a a flush floor.
Wiring for and cables provided in the the enclosure,
or through a side access Top can be
with an optional
Refer to the ACA-2000 manual
number cable
Floor must be considered when installing the EPS-2000 raised floor an upper
story a multiple-story building. Floor data is
the drawings
your structural engineer while planning EPS-2000
installation.
The EPS-2000 a 1 meter inches) front clearance for normal
access maintenance is not required.