REVELATION
Ⅱ
REVELATION
Ⅱ
Alkaline Water Ionizer
Alkaline Water Ionizer
Installation Instructions
Installing Your REVELATION
Ⅱ
Let's get started!
1) Please examine the REVELATION
Ⅱ
box and
contents to insure your new REVELATION
Ⅱ
was
not damaged during shipping. Please contact your
authorized dealer or Water for Life USA
immediately if damage has occured.
2) Remove your REVELATION
Ⅱ
, lay it on its
back and remove the clear cover (sealed at the
bottom of your machine).
3) Open the hardware box where you will find your
cold water line diverter valve, power cord, 1/4 inch
line, water pressure reducer valve for high water
pressure areas (usually cities), and pH drops for
testing your water after installation has been
completed. Please refer to the color chart in this
manual when you are testing your alkaline/purified/
acidic water.
4) Now, we need to remove the plugs from under
the REVELATION
Ⅱ
, inserted in the quick connect
valves. These plugs are very similar to golf tees or
an umbrella with a flat top. These tees prevent
water from leaking from your new
REVELATION
Ⅱ
. Why is there water? All of our
products have been tested for quality control.
Below the cap of the plug on the quick connect
valve is a small, barely visible white ring. Place
your thumb and index fingers below the cap then
press with the tip of your thumb and index finger
toward the quick connect valve, pushing in on the
small ring to release the plug, while at the same
time gently pulling the plug out.
19
Programming the REVELATION
Ⅱ
To Enter into the Mode:
Simultaneously touch the
ALKALINE
and
PURE
sensors for five seconds.
Programming the REVELATION
Ⅱ
Programming your product is not necessary since your REVELATION
Ⅱ
is already set for
optimal performance.
You may want to program: (1) the voice volume/muting. (2) stronger level of ionization to
compensate for hard water or water deficient in minerals (Engineer Mode).
You can exit programming at any time by touching the SET button .
1. Volume Control Option
This allows you to (1) set the voice volume or (2) turn off the voice. Use the
“ALKALINE(
∧
)”
sensor to increase the voice volume. Use the
“PURE(
∨
)”
sensor to decrease the voice volume.
To turn the voice off, continue touching the
“PURE(
∨
)”
sensor. If you have turned off the voice
and want to turn to back on again, touch the
“ALKALINE(
∧
)”
sensor and then adjust the
volume level by using the
“
∧
”
and
“
∨”
buttons.
2. LCD Backlight Option
Touch the
“ACIDIC(>)”
sensor ONCE.
“OFF”
flashes on the display. Switching this option to
“ON”
will keep the backlight on your
REVELATION
Ⅱ
screen constantly lit. We recommend that you keep this option on
“OFF”
so
that the screen only lights up when you touch a sensor.
26
