11
28 c
m
cabin wall
Heater safety
grate
Minimum distances
1. Tighten the 4 sheet metal screws to the cabin wall
according to the measurements in fig.4 and keep a 3
mms gap between screw head and wall.
Fig.5
Fig. 4
5. Secure the sauna heater by tightening the 4 screws.
40 cm
4 cm
4 cm
25,5 cm
4 cm
47,3
cm
32
cm
10 cm
3 mm
2. Connect the power cable as shown in the circuit dia-
gram (Fig 14). A circuit diagram is provided on the inside
of the terminal box cover.
3. Close the terminal box with the cover, using 4 sheet
metal screws.
4. Fit in the sauna heater to the screws with the suspension
slits on the rear side (fig.5)
Fig. 3
Connecting the sensor lines
20 cm
Fig. 6
Mounting the oven sensor
1. Mount the oven sensor in cabins up to
2 x 2m according to Illust. 6and 7, in larger cabins
according to Illust.s 6 and 8.
Fig. 8
Fig. 7
The sensor lines can be passed in the cabin inside
alternatively to avoid the drilling of the ceiling.
19 cm
35 cm
You should not install sensor and power supply lines together,
or lead them through the same conduit. This can lead to
interferences in the electronics, such as "fluttering" in the
switch protectors. If it is absolutely necessary to install them
together, you should use a shielded sensor line such as the
LIYLY-O (4 x 05, mm²).
Connect the shielding to mass in the control unit.
Please note that the following measurements are based
on values provided by the unit quality assurance by the
European Standard EN 60335-53-2. In principle, you must
mount the oven sensor where temperatures are the highest.
Illust. 7 gives you an overview of the mounting point of the
sensor.
english
