20
7. To remove the NYX-14 and turn it around, push the button down (E) and lift the unit up until it reaches
the top position. Once it reaches this position, the unit will turn off automatically.
8. Push the same button (E) to lower the NYX-14 into the proper viewing position. Turn the unit on to
proceed with your mission.
In Figure 3-3, the NYX-14 is shown in the correct position for the right eye. To readjust the NYX-14 for
the left eye, reverse its positioning and reinstall it on the helmet mount bracket (see Figure 3-3). Use the
second unit rail located on the opposite side of the unit. Push the button (F) and move the unit along
the slide-rail (G) until the most comfortable position is reached.
To remove the NYX-14 from the helmet mount, loosen the screw (B), push down on the button (C), and
slide the unit out of the guide (D).
C
D
E
G
B
A
FIGURE 3-3. MOUNTING THE NYX-14 TO A HELMET
F
A
3.1.4 MOUNTING THE NYX-14 TO A DUAL BRIDGE
To install two NYX-14 units onto a single binocular device, use the optional dual bridge. Perform the
following steps:
1. Align the NYX-14 with the dual bridge (A).
2. Press down on the clamps (B) that are located on the front of the bridge.
3. Pull the unit back until the alignment boss is lined up against the groove (C) of the dual bridge. Push
the unit back until it is securely fixed to the dual bridge.
4. Perform steps 1-3 with the second NYX-14 unit.
To remove the NYX-14 from the dual bridge, press down on the front clamps and slide the unit for-
ward.
To configure the NYX-14 for long-range observation with binoculars, mount the 3x accessory lenses to
the units as seen in Part 3.1.6 of this Manual.
To mount the dual bridge to the optional goggle kit, see Part 3.1.2 of this Manual.
C
B
A
FIGURE 3-4. MOUNTING THE NYX-14 TO A DUAL BRIDGE
