Secondary Installation
f
iRe
g
Rate
anD
L
og
s
et
i
nstaLLation
:
The placement of the logs is not arbitrary. If they are positioned incorrectly, the flames can be “pinched”
and will not burn correctly. All of the logs come with either a notch or ledge, which make alignment easier.
Using the pictures provided, carefully set the logs in place (see Figures 37 through 41).
NOTE: The logs are fragile and should be handled gently.
Figure 37. Empty firebox with air diverter, grate, and burner tube
Figure 38. Back Log and Ember Bed Installation
Figure 39. Left and Right Large Logs with Ember Wool
Step 1
: Place the back log on the top legde
of the air diverter as far back as it will go.
Install the ember bed assembly into the
center of the burner tube on the burner
stands as shown. Bring the burner tube
as far forward as you can on the burner
stands while
maintaining parallelism
between all the components in this
step.
Step 2
: Bust up the ember wool
(C-10699) as fine as possible (It is
recommended to use a stiff bristle
brush or tabacoo/coffee grinder).
Place the wool lightly on the burner
tube (just enough to cover about
70% of the front section of the tube).
Place the large left log into position as
shown with the back side flush against
the firebox wall. Place the large right
log into position; the back log has
markings indicating where to line it up.
Figure 34:
This is how
the firebox looks with only
the burner, air diverters,
and log grate in place.
The log grate can be
easily removed by simply
lifting up off the stands.
31
NOTE: The burner tube may need to
be bent by hand slightly in order for
it to seat correctly.
Summary of Contents for Nova Q2
Page 35: ...35 Parts Diagram 2 3 1 18 19 17 16 11 10 13 12 23 15 22 4 9 21 6 5 7 20 8 14 ...
Page 36: ...Notes 36 ...
Page 37: ...Notes 37 ...
