Enviro Nova Q2, Owner'S Manual

Page: 13 / 39

Initial Installation
QUALIFIED INSTALLERS ONLY
i
ntRoDuction
:
This section of the owner’s manual is for the use of qualified technicians only. Fireplace placement,
hearths, facing, mantels, and venting terminations will be covered, as well as the gas and electric
systems. There are several installation safety guidelines that must be adhered to. Please carefully read
the safety precautions at the front of this manual.
NOTE: The Q2 comes as a top vent unit but can be converted to a rear vent.
Warning: Clearances must be sufficient to allow access for maintenance and service.
P
Lacement anD
f
Raming
:
Table 2. Framing Dimensions.
Firebox Framing
Depth 14” 1016mm
Width 34
9/16
” 878mm
Height - Rear Vent 40” 1016mm
Height - Top Vent *48”+ 1219mm
Gas Inlet (Distance
From Back)
4
7/16
” 113mm
Gas Inlet (Height) 1
9/16
” 40mm
The location for the fireplace can be
along a wall, raised, at floor level, or
in a corner. There are specific framing
measurements for each situation.
The basic opening should have the
dimensions shown in Figure 12.
The fireplace must have a strong and
level surface to be placed on. The
surface should be made of wood or a
non-combustible material, not carpet.
The gas line,
3/8”
JIC fitting, should
be brought to the right side of the
fireplace. The location should be
chosen so the fireplace will be at least
Figure 12. Dimensions for Framing the Firebox
36 inches (91.4 cm) from drapes, doors and other combustibles. The framed opening should also
be a minimum of 4 5/8” (11.7 cm) from the nearest perpendicular wall (sidewall to the edge of the
opening).
37
7
/
8
"
(962mm)
36¼"
(921mm)
3
5
/
8
"
(93mm)
13
1
/
4
"
(337mm)
5
5
/
8
"
(143mm)
Gas
Inlet
Adjac
ent w
all
1" min
(25mm)
13
40”
(1016mm)
14”
(356mm)
4
7/16
”
(113mm)
34
9
/
16
”
(878mm)
1
9
/
16
”
(40mm)
* + vertical vent rise (not including elbow)