32
Secondary Installation
o
ptionaL
t
RimmabLe
p
aneLs
:
Modifying the Surround Panel:
The E44 Trimmable Surround Panels are large rectangular panels that may be cut for use in cases that a non-
standard fireplace opening (e.g. an arched opening) is to be filled. Optionally this surround can be left uncut
and placed in front of the fireplace opening.
1. Measure the fireplace opening and/or make a template of the fireplace opening.
2. Transfer the measurement to the Trimmable Surround.
3. If desired, offset the measurements by approximately
1
/
8
” (3mm) to the inside; this will allow for the panel
to be placed just inside the fireplace opening for a cleaner appearance.
4. Cut along the preferred line (from direct measurements of offset) and remove any sharp edges.
5. The panel can be touched up with a high temperature metallic black paint available from your dealer.
INSTALLATION:
1. Using the supplied hardware install the appropriate mounting brackets onto the trimmable panel using a
T-20 Torx screwdriver.
Ensure that the hooks are facing the middle of the panel
.
2. Install the Trimmable Panel by securing the four hooks onto the corresponding slots that are on the front of
the E44 unit (See Figures 41 and 42)
3. Ensure that the trimmable panel is centered on the unit in order for the standard panels to fit easily.
Figure 41:
Panel Slot and
Hook Locations
Figure 42:
Trimmable
Panel Installed
