© The Entryphone Company Limited
20
Setup
IP Setup
The IP settings above are used only if J12 (not J1 as shown on the screen above), also marked
‘Link
to enable DHCP’
is not linked.
Signal quality:
The
signal quality from the GSM modem. Displays the result as x,y where x is the
error rate and should be conventionally 0 if there is no error and y is the signal strength ranging from 0
to 15, where 0 is no signal. The x,y is shown in the
contents of communication buffer.
Hardware Reset:
Performs a reboot of the PinNet board. Suspends normal operation for
approximately 2 seconds.
The
Contents of the communication buffer
and the
Contents of the ring buffer
both record the
communication between the PinNet and the GSM modem.
