Enterasys ROAMABOUT RBT-1602, Installation Manual, Page: 28 / 56

Installing the Access Point
2-10 Installing and Connecting the Access Point
12. Lock the access point onto the bracket by inserting the 3 ‐ mm or 1/8 ‐ inch screwdriver into the
Lock hole on the access point as shown in Figure 2 ‐ 9 .
Figure 2-9 Step 11—Locking the Bracket
13. To ensure that the access point is fully locked onto the bracket, gently pull down on the access
point and attempt to rotate it from side to side.
14. If the access point comes off the bracket, relock the device onto the bracket as described in
Step 12 on page 2 ‐ 10.
15. If the other ends of the Cat 5 cable(s) are not already connected and the link activated, go to
“ Connecting an Access Point to the Network ” on page 2 ‐ 25. Otherwise, go to “ Verifying AP
Health ” on page 2 ‐ 26.
Suspended Ceiling Installation—Drop Ceiling Tiles
(For required mounting hardware and tools, see Table 2 ‐ 2 on page 2 ‐ 5.)
1. Select an installation location that is centered over a T ‐ bar in the ceiling.
2. Cut a hole as follows in the ceiling tile for the Cat 5 cable(s):
a. Place the mounting template over the area where you plan to install the access point.
b. Use the box cutter to cut along the line marking the opening for the port connectors.
c. Remove the mounting template and the material you cut from the ceiling panel.
Caution: To prevent possible damage to the access point, make sure the device is fully locked
onto the bracket before letting go of it.
Advertencia: para evitar posibles daños al punto de acceso, asegúrese de que el dispositivo
esté completamente fijo al soporte antes de soltarlo.
Achtung: Vergewissern Sie sich stets, dass der Access Point vollständig in die Halterung
eingerastet ist, um so Beschädigungen zu vermeiden.
Lock
T-bar