Connecting to Console Port for Local Management
Hardware Installation
3-19
4. Turn on the terminal and access the Setup Directory. Set the following parameters on your
terminal:
When these parameters are set, the Startup screen will display. Proceed to
Section 3.7
to complete
the installation.
Figure 3-15
Connecting a VT Series Terminal
3.6.4
Connecting to a Modem
To connect a modem to an Enterasys Networks device modem port (
Figure 3-16
), use a UTP
straight-through cable with RJ45 connectors and an optional RJ45-to-DB25 male adapter, and
proceed as follows:
1. Connect the RJ45 connector at one end of the cable
to the Console port
on the Enterasys
Networks device.
2. Plug the RJ45 connector at the other end of the cable
into the RJ45-to-DB25 male adapter
.
3. Connect the RJ45-to-DB25 adapter
to the communications port on the modem
.
4. Turn on the modem
and make sure the remote modem
is ON.
Parameter
Setting
Mode
7 Bit Control
Transmit
Transmit=9600
Bits Parity
8 Bits, No Parity
Stop Bit
1 Stop Bit
UTP straight-through cable with RJ45 connectors
RJ45-to-DB25 VT adapter
RJ45 Console port shown on C1H124-48
VT series terminal
CPU
RPS
1
49
51
2
50
52
1
2
52
50
49
51
Ã
Á
Â
À
3831_01_10
